Skip to content
DIS Robotics
ROBOTICS · ENGINEERING · ORIGINAL SOURCES
PRE-PILOT / DEVELOPINGv0.1.0-prepilot · 2026-10-15

COURSE / VERSION 0.1

FOUNDATIONS OF AUTONOMOUS SYSTEMS

An eight-week, simulation-first pathway from bounded Python control to reproducible capstone evidence. The material is ready for adult review and technical testing; it has not yet been delivered to a student pilot.

ENTRY

Basic computer literacy. No robotics kit is required. The host must verify that participant devices can run the selected Webots release.

TWO VALID PATHS

Simulation-only and simulation-plus-hardware are equal learning paths. Hardware availability cannot determine access to the core course.

EVIDENCE

Assessment uses code, logs, calculations, repeat trials, debugging, safety practice, and reproducible instructions—not attendance alone.

Two guided sessions per week

EIGHT-WEEK PLAN

  1. WEEK 1

    Systems, Python, frames, and safety

    SIM: Inspect the rover system, issue bounded wheel commands, and log pose and command data.

    ALTERNATIVE: Label a wiring plan and trace signal, logic-power, and motor-power boundaries without energizing hardware.

    SUBMIT: First controller function, annotated system diagram, and preflight checklist.

    • units
    • coordinate frames
    • Python functions
    • safe-state thinking
    DOWNLOAD MD ↓
  2. WEEK 2

    Differential-drive kinematics

    SIM: Predict and run straight, in-place turn, and constant-radius arc scenarios.

    ALTERNATIVE: Measure or specify wheel radius and wheelbase, then calculate expected motion on paper.

    SUBMIT: Predicted-versus-observed table with units and percentage error.

    • linear velocity
    • angular velocity
    • wheelbase
    • prediction error
    DOWNLOAD MD ↓
  3. WEEK 3

    Sensing, noise, and state machines

    SIM: Build obstacle avoidance with explicit FORWARD, TURN, and STOP states.

    ALTERNATIVE: Classify pre-recorded sensor values and identify false transitions.

    SUBMIT: State diagram, sensor trace, and three documented failure cases.

    • sensor range
    • noise
    • thresholds
    • hysteresis
    • finite-state machines
    DOWNLOAD MD ↓
  4. WEEK 4

    Feedback and bounded control

    SIM: Compare open-loop steering with a bounded heading controller under disturbance.

    ALTERNATIVE: Run the controller over recorded heading samples and explain saturation or wind-up.

    SUBMIT: Controller comparison, chosen gains, and a tuning explanation.

    • error
    • proportional control
    • integral action
    • saturation
    • tuning
    DOWNLOAD MD ↓
  5. WEEK 5

    GPIO, motor drivers, power, and failsafe

    SIM: Enforce command bounds, watchdog timeout, and an explicit disabled state.

    ALTERNATIVE: Adult-supervised de-energized wiring review or circuit simulator; no mains work.

    SUBMIT: Signed safety checklist, interface table, and failsafe test cases.

    • GPIO logic
    • PWM
    • H-bridges
    • separate power domains
    • stop states
    DOWNLOAD MD ↓
  6. WEEK 6

    Encoders, calibration, and repeatability

    SIM: Introduce wheel mismatch, saturation, and noise; estimate correction factors.

    ALTERNATIVE: If an approved kit exists, run low-speed calibration behind a barrier; otherwise use supplied logs.

    SUBMIT: BOM revision, calibration record, and at least three comparable trials.

    • encoder counts
    • PWM mapping
    • calibration
    • repeat trials
    • uncertainty
    DOWNLOAD MD ↓
  7. WEEK 7

    Simulation-to-real comparison

    SIM: Run a fixed path under nominal and disturbed parameter sets.

    ALTERNATIVE: Compare with approved host demo logs only; never invent physical measurements.

    SUBMIT: Deviation table, likely causes, and next validation experiment.

    • matched experiments
    • system identification
    • model limits
    • quantitative deviation
    DOWNLOAD MD ↓
  8. WEEK 8

    Capstone, reliability, and communication

    SIM: Complete the robust obstacle-avoiding rover protocol under two disturbances.

    ALTERNATIVE: Optional supervised matched run only after hardware and venue approval.

    SUBMIT: Code, configuration, telemetry, rubric, limitations, and reproducible run instructions.

    • test protocols
    • fault isolation
    • reproducibility
    • technical reporting
    DOWNLOAD MD ↓

ASSESSMENT / 100

Model understanding
15
Working controller
25
Measurements and testing
20
Engineering debugging
15
Documentation
15
Safety, ethics, collaboration
10

A suggested 70/100 threshold is a pilot hypothesis, not a professional credential.

PROPOSED LICENSE / RIGHTS REVIEW PENDING

Original course text is proposed for CC BY 4.0. Original starter code is proposed for MIT. These choices remain pending rights review; third-party assets keep their own licenses.